pulled my 37 "A" in the shop



replacing bearings in rearend



Axles ready to go back in

Making progress,or making a mess,sometimes I wonder,good thing there are some good folks posting this board that know what they are doing and will help us green horns..............good luck

*******

Got the tractor split had a lil trouble getting the block out







Got the block out,next stop the machine shop.................good luck

I had some time to work on my A,my original plan was to try and clean the crankshaft up in place.
But since the cylinders are wore 26/1000ths over and have to be rebored,I thought I would be better off in the long run haveing the crank turned and the rod bearings repoured.
So I got the fly wheel off I will pull the crankshaft soon............good luck

Got the head back today as you can see replaced one $70 exhaust valve all the others were good .
Ordered my pistons 45 over today ,because the machine shop said the block bored fine.So I will pick it up later next week.............good luck