I guess you can say i'm starting on my H. After some research and thought i ordered a rebuilt head for it. The one that is on it has been brazed i wanted to rebuild the old one but couldn't see pouring money into a broken head. I'm putting some cash away a little at a time so i can move on with the project. I will post photos of the progress as it unfolds.

Last night i started to take the sheet metal off. Only had one broken bolt so far not bad i have been soaking them with PB blaster for three months. More to come later.

Getting more done i ran into some trouble with the fandrive gear. Whoever had it apart before me had it meshed to tight no alot of the gears are chipped off.

So far so good. Have rebuilt head, had to get used block the other was cracked in pushrod tubes. I sent the block to get it rebored using allfuel pistons, rods rebushed, and have rad. tore apart top and bottom tank are in my electrolysis tank cleaning up i'll put a new core in the rad.

I have my block back new pistons and rings. Now i'm going to play around with the gov. to see if i can get that right.