albertbrowne
Jul 3 2004, 09:18 PM
Have tried all the following methods to unstick head: separating chisels between block and head, compressed air applied to cylinders, slide-hammer applied to 5/8ths bolt holes which hold rocker arms. Pistons move freely in cylinders. Head stud nuts are loose. But without cracking the head, does anyone know how to remove it ?
deereman
Jul 14 2004, 10:50 AM
Spray some good penatrating oil on it, and let it crep in between the block and head.
dodgeit
Aug 16 2004, 11:50 AM
There are some tubes that you must undue, if memory serves correctly before the head will come off.
They bring oil to the head / rocker arms.
HTH
Tim
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.