A few pictures of the B I am restoring. started May 2004.
[John Deere B
Block was bad # 1 cylinder
Crank had splines on clutch beat off.
Rebuilt transmission as lower cluster was shot.
Installed new rings and rebuilt crankshaft.
Replaced seals and bearings on rear axles
Gas tank had holes in top.
Working on priming
First coat on green
finally got assembled enough to start
Discovered bearings needed replaced in clutch.
Currently working on finishing touches and sheet metal. Wife asked how much I spent on it told her I did not want to know.
The current plan is to finish for the JD 2 cylinder in Fairview OK in September.
Richard